- Allstar & DMR | piping audio from talkgroup into USB soundcard
Re: Allstar & DMR | piping audio from talkgroup into USB soundcard
toggle quoted messageShow quoted text
Yep, you need a URIx or equivalent.
On Sun, Sep 9, 2018, 17:07 Corey Dean N3FE <n3fe@...
I do not believe the signallink was ever supported in allstar.
On Sun, Sep 9, 2018 at 6:24 PM Lou Michaels <w2lmm.qsl@...
I'm setting up an allstar node to bridge my DMR talkgroup for my local simplex group using a RaspPi.
It appears I got just about everything working and connected with my node. I can send commands and even a 1khz test tone into the talkgroup, which I hear on the DMR radios. So that bit is working; yet the purpose was to have the allstar/RaspPI key one of my radios and go out on analog 2m.
My radio is a FT857D and the interface is a SignalinkUSB. I am able to get the Signalink to PPT via VOX if I play audio on the RaspberryPi, but can't seem to bring audio in from the DMR talkgroup to PPT the Signallink.
I suspect the issue is specifying the audio I/O in Analog_Bridge.ini.
Below is an lsusb output as well as the Audio Device section of Analog_Bridge
I'm a little turned around by this, as I am not sure how to specify the audio IO source; 1. capture the DMR audio and pipe to USB/PCM audio interface into the SignalinkUSB.
I know the comment block says "not normally needed in gateway service" ...so am I on the right track or should I be using chan_usbradio or chan_simpleusb?
I've been trying different configurations and modules, but not having any luck.
Any ideas how I might get this done?
Thanks in advance.
Join main@DVSwitch.groups.io to automatically receive all group messages.