Sounds good. I was going to take another stab at it tonight. 

This being discussed on IRC? If you tell me where, and if open to group, I can hop on in a few

I was to grab the interface at http://dmkeng.com/

Thanks again!

On Sun, Sep 9, 2018, 8:20 PM Steve N4IRS <szingman@...> wrote:

Lou,
Don't quite give up yet. We are discussing.....

Steve N4IRS

On 09/09/2018 05:50 PM, Lou Michaels wrote:

Greetings,

I'm setting up an allstar node to bridge my DMR talkgroup for my local simplex group using a RaspPi.

It appears I got just about everything working and connected with my node. I can send commands and even a 1khz test tone into the talkgroup, which I hear on the DMR radios. So that bit is working; yet the purpose was to have the allstar/RaspPI key one of my radios and go out on analog 2m. 

My radio is a FT857D and the interface is a SignalinkUSB. I am able to get the Signalink to PPT via VOX if I play audio on the RaspberryPi, but can't seem to bring audio in from the DMR talkgroup to PPT the Signallink. 

I suspect the issue is specifying the audio I/O in Analog_Bridge.ini. 

Below is an lsusb output as well as the Audio Device section of Analog_Bridge

https://pastebin.com/HVK7uiRU

I'm a little turned around by this, as I am not sure how to specify the audio IO source; 1. capture the DMR audio and pipe to USB/PCM audio interface into the SignalinkUSB.

I know the comment block says "not normally needed in gateway service" ...so am I on the right track or should I be using chan_usbradio or chan_simpleusb? 

I've been trying different configurations and modules, but not having any luck.

Any ideas how I might get this done? 

Thanks in advance. 

-Lou