- Allstar & DMR | piping audio from talkgroup into USB soundcard
Re: Allstar & DMR | piping audio from talkgroup into USB soundcard
toggle quoted messageShow quoted text
I'll get you this output shortly
On Sun, Sep 9, 2018, 8:45 PM Steve N4IRS <szingman@...
Can you paste the output of aplay -l
On 09/09/2018 05:50 PM, Lou Michaels
I'm setting up an allstar node to bridge my DMR talkgroup for my
local simplex group using a RaspPi.
It appears I got just about everything working and connected with
my node. I can send commands and even a 1khz test tone into the
talkgroup, which I hear on the DMR radios. So that bit is working;
yet the purpose was to have the allstar/RaspPI key one of my
radios and go out on analog 2m.
My radio is a FT857D and the interface is a SignalinkUSB. I am
able to get the Signalink to PPT via VOX if I play audio on the
RaspberryPi, but can't seem to bring audio in from the DMR
talkgroup to PPT the Signallink.
I suspect the issue is specifying the audio I/O in
Below is an lsusb output as well as the Audio Device section of
I'm a little turned around by this, as I am not sure how to
specify the audio IO source; 1. capture the DMR audio and pipe to
USB/PCM audio interface into the SignalinkUSB.
I know the comment block says "not normally needed in gateway
service" ...so am I on the right track or should I be using
chan_usbradio or chan_simpleusb?
I've been trying different configurations and modules, but not
having any luck.
Any ideas how I might get this done?
Thanks in advance.
Join main@DVSwitch.groups.io to automatically receive all group messages.