toggle quoted messageShow quoted text
Thanks Steve, I will look again and follow those instructions, I feel I have just done something silly that I have not been able to see as yet. I have to go out so a break will be good and I may pick up my mistake when I try again later.
Hope this year is good for you.
On 2 Jan 2019, at 12:18 pm, Steve N4IRS <szingman@...
You are correct in your diagram. You are talking about 5 config
files. Rather then search through 5 files, start at one end and
work to the other. Run each program in the foreground one at a
time. If the output to the console looks right, start up a new
shell and work on the next program. Don't move on to the next
program until you have it working up to that point. Yes, you will
end up with 5 shells open. You will be able to watch the traffic
from one end to the other. Once you have that working, follow the
traffic in the other direction.
Pretty much each program at startup reports the important
Hope this helps.
On 1/1/19 8:10 PM, Ian Tulley wrote:
Hi and a Happy New Year to all.
OK, I have done something very silly, I am trying to build a new
server that will be the P25<-->DMR Bridge. I had one working
but needed to move it to a new server and firstly did not check to
see if it was actually running or not, so I don't know if my
original was working. I just want to see if I have the bridging
The reason I am asking is that I shutdown the old server before
making sure the new one was active and now can't seem to get the
new server to work.
I have the P25Gateway working and have one instance of
MMDVM_Bridge.ini and both Analog_Bridge_p25.ini and
Before I do my head in any further I want to check if that looks
correct, if so and I still can't get it to work, I will then
upload my stanzas to see if someone else can see my mistake.