Your id you are using to connect to 3108 with?

On Wed, Jan 23, 2019 at 2:45 PM K4VL <73dek4vl@...> wrote:

3108

On Wed, Jan 23, 2019 at 1:42 PM Corey Dean N3FE <n3fe@...> wrote:

What master are you trying to connect to?

Corey n3fe

On Wed, Jan 23, 2019 at 2:37 PM K4VL <73dek4vl@...> wrote:

I was wondering... Could my problem be that  my gatewayDmrId in the Analog_Bridge.ini is the same as the Radio ID in my handheld radio? Do I need to get another DMR ID?

On Wed, Jan 23, 2019 at 1:31 PM Steve N4IRS <szingman@...> wrote:

These are the items in MMDVM_Bridge.in that deal with logging into a Master:
[General]
Callsign=W1AW
Id=3112111
Duplex=0

[DMR Network]
Enable=1
Address=310x.repeater.net
Port=62031
Jitter=500
Local=62032
Password=passw0rd
Slot1=1
Slot2=1
Debug=0

On 1/23/2019 2:26 PM, K4VL wrote:

The password under DMR Network is correct

On Wed, Jan 23, 2019 at 1:22 PM Steve N4IRS <szingman@...> wrote:

Check your password. Should be passw0rd Notice the 0

On 1/23/2019 2:20 PM, K4VL wrote:

OK I can see when I key up the last line that comes up says Login to master has failed, retrying login ...

On Wed, Jan 23, 2019 at 1:11 PM Steve N4IRS <szingman@...> wrote:

Run the program(s) in the foreground to look for errors.
Running the program in the foreground simply means starting the program from the command prompt.
Example: root@myhost:/opt/MMDVM_Bridge# ./MMDVM_Host MMDVM.ini This runs the program from the prompt. Notice the ./ in front of the program name. This means run the program in this directory.

On 1/23/2019 2:09 PM, K4VL wrote:

forgive my ignorance but I don't know how to run it in the foreground

On Wed, Jan 23, 2019 at 1:06 PM Steve N4IRS <szingman@...> wrote:

Hoseline has been up and down. First check your self care page and make sure MMDVM_Bridge is logged in to BM. Running MMDVM_Bridge in the foreground will also tell you if it is connected to BM.

On 1/23/2019 2:04 PM, K4VL wrote:

I did see that I am connected to Brandmeister it has me wondering if my radio is not programmed correctly. I did also try to click on hoseline and got a 503 service unavailable page.

On Wed, Jan 23, 2019 at 12:50 PM Steve N4IRS <szingman@...> wrote:

Not a lot of information to go on but in general:
Run each program in the foreground so you can see what is happening. Start at one end and work to the other end.

Steve

On 1/23/2019 1:42 PM, K4VL wrote:

I was wondering how to test my bridge? I don't seem to be getting to it through my hotspot. I went to the CLI and keyed my radio and nothing showed up. My server is setup as 311628005 and my talkgroup is 310286.

Thanks