toggle quoted messageShow quoted text
On Wed, Jan 23, 2019 at 2:02 PM Corey Dean N3FE <n3fe@...
I don’t want to post the logs here as it has your ip address in it, but I can confirm you have connected and disconnected many times in the last few hours. I also see where traffic was coming from bm toward you a few times but I didn’t not verify the talkgroup.
My server is setup as 311628005 and my talkgroup is 310286
On Wed, Jan 23, 2019 at 1:56 PM Corey Dean N3FE <n3fe@...
Your id you are using to connect to 3108 with?
On Wed, Jan 23, 2019 at 1:42 PM Corey Dean N3FE <n3fe@...
What master are you trying to connect to?
I was wondering... Could my problem be that my gatewayDmrId in the Analog_Bridge.ini is the same as the Radio ID in my handheld radio? Do I need to get another DMR ID?
On Wed, Jan 23, 2019 at 1:31 PM Steve N4IRS <szingman@...
These are the items in MMDVM_Bridge.in that deal with logging into a
On 1/23/2019 2:26 PM, K4VL wrote:
The password under DMR Network is correct
On Wed, Jan 23, 2019 at 1:22
PM Steve N4IRS <szingman@...
Check your password. Should be
passw0rd Notice the 0
1/23/2019 2:20 PM, K4VL wrote:
OK I can see when I key up the last line
that comes up says Login to master has failed, retrying
Jan 23, 2019 at 1:11 PM Steve N4IRS <szingman@...
Run the program(s) in the
foreground to look for errors.
Running the program in the foreground simply means
starting the program from the command prompt.
Example: root@myhost:/opt/MMDVM_Bridge# ./MMDVM_Host
MMDVM.ini This runs the program from the prompt.
Notice the ./ in front of the program name. This
means run the program in this directory.
1/23/2019 2:09 PM, K4VL wrote:
forgive my ignorance but I don't
know how to run it in the foreground
Wed, Jan 23, 2019 at 1:06 PM Steve N4IRS <szingman@...
Hoseline has been up
and down. First check your self care page
and make sure MMDVM_Bridge is logged in to
BM. Running MMDVM_Bridge in the foreground
will also tell you if it is connected to BM.
1/23/2019 2:04 PM, K4VL wrote:
I did see that I am
connected to Brandmeister it has me
wondering if my radio is not programmed
correctly. I did also try to click on
hoseline and got a 503 service
Wed, Jan 23, 2019 at 12:50 PM Steve
Not a lot of
information to go on but in general:
Run each program in the foreground
so you can see what is happening.
Start at one end and work to the
1/23/2019 1:42 PM, K4VL wrote:
wondering how to test my bridge? I
don't seem to be getting to it
through my hotspot. I went to the
CLI and keyed my radio and nothing
showed up. My server is setup as
311628005 and my talkgroup is