This is what I have:
[505501]
; Change this to your assigned
node number
; Must also be enabled in
modules.conf
; Rx audio/signalling channel.
Choose ONLY 1 per node stanza
; Enable the selected channel
driver in modules.conf !!!
;
rxchannel = dahdi/pseudo ; No radio (hub)
;
rxchannel = SimpleUSB/usb_505501 ; SimpleUSB
;
rxchannel = Pi/1 ; Raspberry Pi PiTA
;
rxchannel = Radio/usb_505501 ; USBRadio (DSP)
;
rxchannel = Dahdi/1 ; PCI Quad card
;
rxchannel = Beagle/1 ; BeagleBoard
rxchannel
= USRP/127.0.0.1:34001:32001 ; GNU Radio interface USRP
duplex =
1 ; 0 = Half duplex with no
telemetry tones or hang time.
; Special Case: Full duplex
if linktolink is set to yes.
; This mode is preferred
when interfacing with an external multiport repeater
controller.
; Comment out idrecording
and idtalkover to suppress IDs also
; 1 = Half duplex with telemetry
tones and hang time. Does not repeat audio.
; This mode is preferred
when interfacing a simplex node.
; 2 = Full Duplex with telemetry
tones and hang time.
; This mode is preferred
when interfacing a repeater.
; 3 = Full Duplex with telemetry
tones and hang time, but no repeated audio.
; 4 = Full Duplex with telemetry
tones and hang time. Repeated audio only when the autopatch is
down.
linktolink
= Yes ; disables forcing physical
half-duplex operation of main repeater while
; still keeping half-duplex
semantics (optional)
linkmongain
= 0 ; Link Monitor Gain adjusts the
audio level of monitored nodes when a signal from another node
or the local receiver is received.
; If linkmongain is set to a
negative number the monitored audio will decrease by the set
amount in db.
; If linkmongain set to a
positive number monitored audio will increase by the set
amount in db.
; The value of linkmongain is in
db. The default value is 0 db.
erxgain =
-3 ; Echolink receive gain
adjustment
; Note: Gain is in db-volts
(20logVI/VO)
etxgain =
3 ; Echolink transmit gain
adjustment
; Note: Gain is in db-volts
(20logVI/VO)
;eannmode
= 1 ; 1 = Say only node number on
echolink connects (default = 1)
; 2 = say phonetic call sign
only on echolink connects
; 3 = say phonetic call sign and
node number on echolink connects
