Re: Help after editing rpt.conf. Not sure why?


Steve N4IRS
 

Show the 1999 stanza

On 12/31/19 8:07 AM, Ted Lawrence via Groups.Io wrote:
This is what I have: 

[505501]                                ; Change this to your assigned node number

 

                                        ; Must also be enabled in modules.conf

                                        ; Rx audio/signalling channel. Choose ONLY 1 per node stanza

 

                                        ; Enable the selected channel driver in modules.conf !!!

; rxchannel = dahdi/pseudo              ; No radio (hub)

; rxchannel = SimpleUSB/usb_505501      ; SimpleUSB

; rxchannel = Pi/1                      ; Raspberry Pi PiTA 

; rxchannel = Radio/usb_505501          ; USBRadio (DSP) 

; rxchannel = Dahdi/1                   ; PCI Quad card 

; rxchannel = Beagle/1                  ; BeagleBoard

rxchannel = USRP/127.0.0.1:34001:32001  ; GNU Radio interface USRP

 

duplex = 1                              ; 0 = Half duplex with no telemetry tones or hang time.

                                        ;     Special Case: Full duplex if linktolink is set to yes.

                                        ;     This mode is preferred when interfacing with an external multiport repeater controller.

                                        ;     Comment out idrecording and idtalkover to suppress IDs also

                                        ; 1 = Half duplex with telemetry tones and hang time. Does not repeat audio.

                                        ;     This mode is preferred when interfacing a simplex node.

                                        ; 2 = Full Duplex with telemetry tones and hang time.

                                        ;     This mode is preferred when interfacing a repeater.

                                        ; 3 = Full Duplex with telemetry tones and hang time, but no repeated audio.

                                        ; 4 = Full Duplex with telemetry tones and hang time. Repeated audio only when the autopatch is down.

 

linktolink = Yes                        ; disables forcing physical half-duplex operation of main repeater while

                                        ; still keeping half-duplex semantics (optional)

 

linkmongain = 0                         ; Link Monitor Gain adjusts the audio level of monitored nodes when a signal from another node or the local receiver is received.

                                        ; If linkmongain is set to a negative number the monitored audio will decrease by the set amount in db.

                                        ; If linkmongain set to a positive number monitored audio will increase by the set amount in db.

                                        ; The value of linkmongain is in db. The default value is 0 db.

 

erxgain = -3                            ; Echolink receive gain adjustment

                                        ; Note: Gain is in db-volts (20logVI/VO)

etxgain = 3                             ; Echolink transmit gain adjustment

                                        ; Note: Gain is in db-volts (20logVI/VO)

;eannmode = 1                           ; 1 = Say only node number on echolink connects (default = 1)

                                        ; 2 = say phonetic call sign only on echolink connects

                                        ; 3 = say phonetic call sign and node number on echolink connects

 

Join main@DVSwitch.groups.io to automatically receive all group messages.