Hi Folks,I've worked through the "ASL to DMR Bridge How To" pdf and I think I have things more or less set up - I get the expected CLI output when running MMDVM_Bridge and Analog_Bridge in the foreground per the doc.I'm connecting to TG 91 (Worlwide) in Analog_bridge.ini thusly:[AMBE_AUDIO]
address = 127.0.0.1 ; IP address of xx_Bridge
txPort = 31103 ; Transmit TLV frames to partner on this port
rxPort = 31100 ; Listen for TLV frames from partner on this port
ambeMode = DMR ; DMR, DMR_IPSC, DSTAR, NXDN, P25, YSFN, YSFW (encode PCM to this f$
minTxTimeMS = 2500 ; Minimum time in MS for hang delay (0-10000)
; The metadata below is used when ASL is the source since it does not have any concept of digital modes
gatewayDmrId = 310307899 ; ID to use when transmitting from Analog_Bridge
repeaterID = 310307801 ; ID of source repeater
txTg = 91 ; TG to use for all frames sent from Analog_Bridge -> xx_Bridge
txTs = 2 ; Slot to use for frames sent from Analog_Bridge -> xx_Bridge
colorCode = 1
I'm monitoring the TG from a separate Pi-Star hotspot's dashboard. When there's an ongoing transmission from a 3rd party and I hit the PTT on my analog radio and release, the connection starts up and I hear 3rd party on my analog radio listening on the ASL side. However, if the 3rd party stops transmitting and a second 3rd party begins transmitting I don't hear their transmission until I hit the PTT momentarily on my analog radio again. Also, when I hit the PTT on my analog radio I don't see the traffic pop up on the Pi-Star dashboard.
I'm a total newb at this so just hoping for a pointer as to where to start looking.
Best,
Gerry.
W6WNG
