Frank C. D'Amato
I set up a Raspberry Pi last week with Hamvoip. The Allstar Node is up and running and RF is connected. It has a private node 1999 also.
I installed DVSwitch on the second Pi (No ALS)
I followed the DVSwitch Installation and User Guide v1.61.pdf instructions but am stuck at the pyUC
I unzipped the USRP Client and copied it to home/pyUC
I ran the following command;
sudo apt-get install python3-pyaudio
sudo apt-get install portaudio19-dev
sudo apt-get install python3-pil.imagetk
I edited the pyUC.ini file
and did a sudo chmod 775 pyUC.py
When I try to execute pyUC.py (by typing pyUC.py) I get "a -bash: pyUC.py: command not found"
Why would I get this error?
My MMDVM_Bridge shows my callsign when I key my radio to the designated TG
My ANALOG_Bridge shows my callsign when I key my radio to the designated TG
I don't see any instructions on setting up the MD-380 Emulator, or how to finally connect the DVSwitch to my Hamvoip Allstar Node located at 192.168.1.9 on my network