Re: Interface Icom D-Star repeater to DVSwitch?
|
Lloyd Duck
You can setup the ICom D-Star repeater and use Centos 7 and make it a G3 gateway (new stuff) or use Pi-Star image and use a raspberry pi for the gateway.
toggle quoted message
Show quoted text
Lloyd, W5LND On Dec 31, 2020, at 3:20 PM, Jim Kusznir <jim@...> wrote:
Hello: I'm probably off-base here, but hopefully someone can point me in the right direction... I have an Icom D-Star DV repeater (eg, ID-RP4000V and ID-RP2C). The gateway software (which apparently requires Centos 5!) seems to not have been updated in a decade or so....But I'm not finding any other instructions on how to enable this perfectly good hardware to participate in a D-Star network. Can a component of DV Switch provide the IP interface that the controller is looking for to allow this RF system to be fully D-Star enabled (connected)? If not, is there another project or direction I should look before trying to build a Centos 5 VM and find the ancient versions of software that the Icom CD that shipped with the repeater requires? I greatly appreciate your help! Thanks! --Jim, K7LL |
|
|