My "Connected Gateways" section shows duplicate entries for certain gateways. Anyone know why this may be happening? Timestamps are about 2 minutes apart for each dupe - the section looks like this:

Hi Florian Would you let me know to install Analog_bridge.armv6l and mmdvm_bridge. armv6l on Raspi zero w ?

Posted on March 24, 2020 by k7udr in D-STAR, DMR, Fusion, ThumbDV | Comments Offon Stay at Home SALE on the ThumbDV™ The “Stay at Home” order by Governor Inslee of Washington State, has impacted

It appears to have corrected itself. Tried this morning and audio passing thru all modes! THANKS FOR ALL THE HELP!!

You're typing "port address" when you mean port number. I think that's why you are confusing JJ et al. Assuming they're all running on the same host, they will all use the localhost IP ADDRESS

If only it were so. In the diagram below (if I understand it) you have NXDN, DMR and YSFn all enabled. That's fine but NXDN is going to need to point it's TX and RX UDP ports at another mode (or

Port address, not IP. As same with each P25 NXDN DMR etc service instance that is on the same server. A separate PORT ADDRESS will be needed for each instance of a service running

Maybe it's just a matter of what you and I are calling thing? I read "address" as an IP Address which does not need to be unique at all. All that needs to happen is each mode has an ASL node which

I was referring to the USRP address. One address set for each node.

You are correct with your design. Not sure what "address" needs to be different.. but each would require it's own node entry in your ASL config and then you would need to link those ASL nodes

The only thing I can see to note is that you will need 3 nodes. One for EACH AB you are showing. Each will need a unique address on the same server. Perhaps there is more I am over

Would this seem like a appropriate all mode solution? Or am i over complicating this? I am not sure on the DStar

Exactly what i needed to know, thanks Steve

The only way to bridge USRP across more then 2 connections is with ASL. The other issue to consider is that you don't ALWAYS want to go analog for conversion. Consider this: DMR, NXDN,

Bridge more than one (all?) digital modes together

What exactly is your ultimate goal?

So i have a simple DMR to P25 Gateway working by piggybacking 2 instances of Analog_Bridge. I would like to add more modes, what process or component ties more than 2 Analog Bridges together?

Oh, and when I start ircddbgateway up and it links to the XLX - I do get audio from ircddbgateway itself back to analog announcing the connection.. I know it has to be some trivial setting in

So I managed to solve my first issue where ircddbgateway etc would not connect to XLX. Turns out that XLX is very picky about padding and I needed to add some additional padding in the ircddbgateway

Show a snip of your life when transmitting from NXDN ALL the way through to ircddbgateway. Sent via smoke signal (AT&T)