Ok. I didn't know about that part of analog_bridge.ini. What I'm aiming for is to use the AMBE board rather than md380emu and be able to use the DV-Switch mobile app. It was my understanding that

Can you tell me what do you want to do with it on the Pi? I used the Zum Ambeboard as vocoder hardware for Analog_Bridge. So upon inserting the configured SD card (Ambe Server mode with IP address

I had that part done, but I wasn't sure if there was anything special to do on the Pi. I selected the AMBE device, etc, but wasn't getting anywhere on DMR or other modes.

I setup one before, you just need to set it up using the configurator in the Zum website. Afterwards you just copy the created file to the included SD card, insert it to the ambeboard and you should

Hello all. I’ve seen references to using the various AMBE thumb sticks, but has anyone used the Zumspot AMBE server with their installation of EA5GVK’s image? I have the Zumspot device that works

dvlink dvlink

What is the login and password for V8 Virtual machine? -- jb N4NQY

AND.... That was easy. working like a champ.

I would login to selfcare and set the password. I believe BM wants people to move away from passw0rd so you may want to choose a unique password. Steve N4IRS

Greetings. I have had a DMR-P25 DVSWITCH running succesfully for a few months. About a week ago the brandmeister connection dropped off and I am seeing M: 2020-01-29 06:31:49.848 DMR, Closing DMR

Correct Sent by smoke signal (AT&T)

AH... So no analog bridge for this since no transcoding?

As I said, Cross connect TX to RX and RX to TX [DMR] Address = 127.0.0.1 ; Address to send AMBE TLV frames to (export) TXPort = 31015 ; Port to

This is a DMR<->NXDN. I wasn't sure if the MD380 server was needed, so I put it in there anyway. I read it wasn't needed for DMR/NXDN/YSF but I intend on added P25 to the Mix at some point and

Bill, I'm a little confused. This is a DMR to NXDN bridge? I believe it is based on your first message. You don't need a transcoder to bridge DMR <-> NXDN Here is the flow diagram.

So in troubleshooting, I came in from the NXDN side and and was able to hit MMDVM_Bridge: M: 2020-01-29 00:52:16.252 NXDN, received network transmission from N2WNS to TG 31360 M: 2020-01-29

Yes it does. I'm going to spin up the gateway that came with NXDNClients. I'll post back results.

That tells us that MMDVM_Bridge is sending to NXDNGateway.

Sorry about that. I only enabled the Network Debug. Here's the output of the general. I shortened it but you'll get the gist: M: 2020-01-28 02:47:55.522 Opening Icom connection I: 2020-01-28

Did you enable debug in the General stanza or the Network stanza? or both. I want just the General stanza.