Hey Steve, The md380-emu has been rock solid in all the bridges I have running. 73 de K4SQI! Steve, K4SQI -- ----- Steve, kb7sqi@...

I am rebuilding my ASL <> Brandmeister bridge….. Should I continue to use the DV3000 or have you found that emu380 is doing a better job? Steve K4KSA

thanks i may have to add a master , As i did add the HB-Bridge.cfg file -- Bob KC2CWT kc2cwt@... (914)497-5502

Hi Bob, No or Maybe... If you did nothing to change the TS/TG routing and let the c-Bridge handle the TG "distribution" then no you don't.  If you monkeyed with the TG/TS routing then yes and maybe

I have HB_link set up for my open spot to the C bridge Now i what to and a mmdvm repeater do i have to make a new Master . thanks -- Bob KC2CWT kc2cwt@... (914)497-5502

Change to AUDIO_USE_GAIN and set the value to less then 1. I would start with .5 if it's hot and adjust up or down as needed. Steve

Hi Steve, is there any recommended value for the audio level between DMR and P25 that works best? Getting a little bit of distortion on both sides ? Thanks, J [USRP] server = 127.0.0.1

Chris, My explanation is not in defense of your comment, and I'm not offended.  While I don't remember seeing your post or the response to it, that isn't the answer you should have received.  As I

Alright boys… give that a shot. -- Cort Buffington H: +1-785-813-1501 M: +1-785-865-7206

Kevin, I'm sorry if I offended you with that light hearted comment. I can only imagine what work goes into keeping this thing up. I was not looking for someone to hold my hand when I wrote an email

Ah OK, I didn't get that from the config text I was hoping to link pairs or Masters as trunk group, will have to look again. Sent from Outlook From: main@DVSwitch.groups.io <main@DVSwitch.groups.io>

Any system you designate as “TRUNK” will become one. There was never a limitation to one. All “TRUNK” does is remove the contention handler completely. I don’t use it a lot, but N3FE who

Hehe, yes got that after looking at it for a bit, all rebuilt now just under 1000 lines in my config! Swapped over into operation, and seems OK from my limited testing. Best not to tell the users or

DO NOT junk the HSOs I'll take them. Steve

I’ll take the PAs and you can junk the rest :) -- Cort Buffington H: +1-785-813-1501 M: +1-785-865-7206

Oh hell – yes, it would be less expensive to just buy one than to ship one of those monsters – Peter, you’re off the hook for now, but someday I’ll need some trinket you have that weighs

You just have to switch thinking that the configuration is centered on a group of arbitrarily named “conference bridges”. Each conference bridge is just like a telephone conference bridge –

Cort, I don't have any GE/Johnson/Moto PA's BUT I do have a couple complete 100w MSF5000 UHF repeaters tuned up on the ham band... the price is right but the shipping would be insane! You or Gavin

Bridge.py is GREAT! Not hard to do at all, in fact very logical and really flexible! Just my tuppence :) Having a go with confBridge, but its quite difficult to get it to do what because of the

Hi Cort, Don't have any of the kit sorry, and it might be difficult to get it across the pond! BUT! If you've got a PayPal, I'm happy to chip in a few bucks if that's of use, for all the help