Sergio, The port number can be changed. edit /lib/systemd/system/webproxy.service See this line: ExecStart=/usr/bin/node /opt/Web_Proxy/proxy.js 8080 2222 edit to taste

Hi Steve and all, Is possible change port 8080? This port is to use for the other machine. Thank you.

Yes, that's correct, because both ircDDBGateway and xlxd are able to listen for incoming traffic on the same protocols.  You need to bind them to separate IPs, or run them on separate servers.  I

You are correct, xlxd doesn't need the AMBE chip or server, unless you actually want to transcode.  I'm running an xlxd reflector without the AMBE transcoder.  I am using primarily two modules. 

As I found, without 127.0.0.1 xlxd is not listening on any UDP ports. I did not think xlxd HAD to be used with a vocoder if all it was to do is be a D-Star reflector. Not high on my list of

If I am not mistaken the 127.0.0.1 is supposed to be ambed.

I believe it is looking for AMBE transcoding. I am no expert though. Just trying to help :) -- Doug Gooden troytrojan@...

So, I was playing around this morning. I'll preface this as I can't even spell xlxd. I find xlxd listens on a number of UDP ports, some of which conflict with ircDDBGateway. This is a systemctl status

Ircddbgateway is installed by the image or by the system builder script. Sent by smoke signal (AT&T)

Complete bridge end to end. From what you told me, if only one bridge is running it works fine (either one) I want you to capture the UDP data for tach bridge running on its own.

root@dvswitch-server:/opt/dmr_utils3# ls dmr_utils3 install.sh LICENSE README.rst setup.py root@dvswitch-server:/opt/dmr_utils3# cd dmr_utils3 root@dvswitch-server:/opt/dmr_utils3/dmr_utils3#

Sorry meant to say Steve, was talking to K2KXK Ken when I was typing.

Ken For clarification. When you say bridge are you referring to the MB instances only, or the complete bridge end to end..... i.e MB only for my YSF to DMR, then stop that MB, and for the P25 to DMR

Gary, That is not what I suggested yo do. This is. With only one of your bridges running, run /opt/MMDVM_Bridge/dvswitch.sh getUDPPortsForProcess ALL The stop that bridge and

Now the files are attached.

Steve, I ran dvswitch.sh getUDPPortsForProcess ALL with all instances of MB and AB stopped. With all instances stopped the only ports showing in use where those associated with P25Gateway 6074,

I'm not sure I understand your comment about the channels then. I should only need two channels to transcode between D-STAR and DMR within xlxd via ambed. Isn't the point of MMDVMBrdige/DVSwitch to

Things have changed since 2017. I suggest you ask here <https://dvswitch.groups.io/g/HBlink> Steve N4IRS

It is creating the folder dmr/utils/ directory I did ls and I hope this screencap shows the error. I'm running this on my dvswitch pi. later 73 Don va7dgp

Its not a hardware problem. Only 2 channels are being used. With the third not being used. That's where the problem lies. You need a pair. Get Outlook for Android