Steve and All, I have had this problem since the new DVSwitch server software was released and it does appear to be intermittent. To keep this from occurring I turned off logging in the Analog_Bridge.

Steve, Ok, I put one server running P25 and NXDN with bridging to hblink3 master hub back to the stock versions of Analog_Bridge V161 and MMDVM_Bridge V163. So far after turning on the Analog_Bridge l

Steve, Ok, let me start with the YSF Reflector error. Attached is the reflector log file from 3/27/21 which shows the error message occurring approximately 4 full screens from the top of the file. I h

Hi Kit, My guess, it is related to the new DVSwitch. I also am running both YSF Reflector and XLX reflector on the same server. XLX would not run as DVSwitch was opening some of the ports for itself t

Having problems running the new DVSwitch modules on same server as these reflectors. XLX problem: using buster repository and DVSwitch, XLX cannot open the key UDP ports as DVSwitch seems to be using

Trying to understand how to use the new DVSwitch-Server to bridge from P25 to DMR. Using the old DVSwitch bridging, two instances of Analog_Bridge were required, which I assume is still necessary but

Steve, You can register on the new TGIF server by going to the WEB page: prime.tgif.network. There at the top is a link to login or register. Registering gives you capability to go to self-care and ge

Ok, thanks, I'll give this a try, else I'll do a clean install.

Went through the process to install Allstar node on Debian10 amd64 cloud server which was already running multiple bridges (FCS / DMR, NXDN reflector and bridge NXDN / DMR and P25 Reflector and bridge

Steve, That did the trick. Thanks again!

Don't think my previous post reply went through so sending Analog_Bridge.ini again.

Not exactly sure what you are asking for, here are log files from Analog_Bridge and MMDVM_Bridge.

Yes, this was a clean install on a cloud server as I re-imaged the server with Debian 10 amd64 buster prior to the installation following your original Allstar / DVSwitch-Server installation procedure

Hi Steve, See alot of remote client connected then disconnected. Attache is the proxy.log file. Thanks

Installed the new DVSwitch-Server on cloud server and doing bridge from an Allstar node to DMR. Bridge works perfectly as does the DVSwitch dashboard. What I cannot get to work is RX Monitor audio thr

Steve, Yes, success!!! Works perfectly. On you install instructions, a note: Installing the new MMDVM_Bridge module, just doing the systemctl stop command and replacing the existing MMDVM_Bridge modul

Steve, Result of -v command: MMDVM_Bridge version 20201105_V1.6.1 git #0a3bff0 We are running all bridging on cloud server running 'Debian 10 Buster x64' and using the DVSwitch module 'MMDVM_Bridge.am

Steve, Not sure about the command you are asking me to execute /opt/MMDVM_Bridge -v This results in command not found. I think you are asking for the version of MMDVM_Bridge which is 1.6.1 for the NXD

Steve, Tx on FCS00379 The log message is on the NXDN MMDVM_Bridge: "M: 2020-12-12 14:37:26.510 DMR Slot 2, received network voice header from WB6DTB to TG 30639" "M: 2020-12-12 14:37:26.510 DMR Slot 2

I posted an issue several months ago concerning getting the error message 'Network Watchdog Timeout' after any FCS transmission using an MMDVM_Bridge between FCS and DMR. Specifically this caused anot