Getting a Burp Voice Message through ASL <> DMR Bridge #mmdvm_bridge
|
Ted Lawrence
Hi Folks!
I have 2 nodes running. Node 505501 ASL<>DMR DV-Switch Bridge on one Raspberry Pi and Stand alone Node 505500 Raspberry Pi remote base UHF. When the two nodes are linked, I get what sounds like a short voice message that sound line the word " burped " after the remote base courtesy tone. This happens when the remote base receives a siginal. Can someone explain ? How do I stop this message behavior? Sincerely, Ted KD4EG
|
|
|
|
Jeff Lehman, N8ACL
the message is probably "blocked" in a female voice. this means
that your bridge has been blocked for an hour for too many keyups
in a certain amount of time. One thing that I found is to increase your tx timer. That might help to eliminate that. I don't have access to my system right this second, so I don't remember what a good setting is, but that will help. Maybe someone can suggest a good value. Jeff On 12/30/19 3:02 PM, Ted Lawrence via
Groups.Io wrote:
Hi Folks! -- Jeff Lehman, N8ACL E-mail: N8ACL@... Hamshack Hotline: 4218 Webmaster Hamilton County ARPSC http://www.hamcoarpsc.org E-mail: info@... Phone: 513-452-6480
|
|
|
|
increase minTxTimeMS to between 2500 and 3000 in the [AMBE_Audio] stanza of Analog_Bridge.ini
toggle quoted messageShow quoted text
On 12/30/19 3:06 PM, Jeff Lehman, N8ACL
via Groups.Io wrote:
|
|
|
|
Ted Lawrence
Thanks for the help. Will make changes and try again.
|
|
|
|
Ted Lawrence
So to be clear. The burp message is a response from the network. Not the node software?
|
|
|
|
Correct
|
|
|