Thanks Steve.

In the log snippets below, AK2L was on one YSF reflector and K7VTT was on another.  K7VTT's radio reported that AK2L was 3,000+ miles away.  When both operators are on the same reflector -- not going through the bridge -- the number reported is +/- 17 miles.

*** First end of bridge showing AK2L transmitting correct coordinates from his FT-991A

M: 2022-02-22 20:34:07.293 YSF, received network data from AK2L       to ALL        at W7AI      

I: 2022-02-22 20:34:07.293 YSF, Lookup call AK2L returned id 0 -> 1234567

M: 2022-02-22 20:34:08.093 YSF, GPS Position from AK2L       on radio=FT-991 is lat=32.338001 long=-111.096336

M: 2022-02-22 20:34:22.288 YSF, received network end of transmission, 15.1 seconds, 0% packet loss, BER: 0.0%

M: 2022-02-22 20:34:24.832 YSF, TX state = ON

I: 2022-02-22 20:34:24.832 YSF, Begin TX: src=1234567 rpt=0 dst=9 slot=2 cc=0 metadata=K7VTT

I: 2022-02-22 20:34:25.035 YSF, Narrow transmit (72 bit)

M: 2022-02-22 20:34:29.729 YSF, TX state = OFF

*** Other end of bridge showing K7VTT transmitting correct coordinates from his FTM-100D

M: 2022-02-22 20:33:58.412 YSF, received network data from K7VTT      to ALL        at W7AI      

I: 2022-02-22 20:33:58.412 YSF, Lookup call K7VTT returned id 0 -> 1234567

M: 2022-02-22 20:33:59.215 YSF, GPS Position from K7VTT      on radio=FTM-100D is lat=32.554501 long=-110.934166

M: 2022-02-22 20:34:05.621 YSF, received network end of transmission, 7.3 seconds, 0% packet loss, BER: 0.0%

M: 2022-02-22 20:34:07.298 YSF, TX state = ON

I: 2022-02-22 20:34:07.298 YSF, Begin TX: src=1234567 rpt=0 dst=9 slot=2 cc=0 metadata=AK2L

I: 2022-02-22 20:34:07.498 YSF, Narrow transmit (72 bit)

M: 2022-02-22 20:34:22.289 YSF, TX state = OFF

M: 2022-02-22 20:34:24.827 YSF, received network data from K7VTT      to ALL        at W7AI      

I: 2022-02-22 20:34:24.827 YSF, Lookup call K7VTT returned id 0 -> 1234567

M: 2022-02-22 20:34:25.632 YSF, GPS Position from K7VTT      on radio=FTM-100D is lat=32.554501 long=-110.934166

M: 2022-02-22 20:34:29.724 YSF, received network end of transmission, 5.0 seconds, 0% packet loss, BER: 0.0%

 

I have two YSF reflectors connected with DVSwitch/MMDVM-Bridge.  They have been active for over 2 years and pass audio just fine.

There is a small problem: Location data (Lat/Long) does not cross the bridge.  If two users are sharing the same reflector -- that is, not using the bridge -- they may show as being 5.5 miles apart.  However, if the two users are on different reflectors, they show as being 3,000+ miles apart, even when they are only a few miles apart.

Is there a setting I can correct to make this work?  Is there an update that addresses this?

Thanks.