Hi Steve, we have installed a public DVswitch server pool. Is it possible APP or hUC USRB client (feature, time later) switch automaticly to the next server entry if selected fails, not reachable, or

Hello all, following many tutorials and hows to, and studying and again studying I succesfully manage to install hblink on a amhf rockchip processor board. It starts and also dashboard is working fine

Hey guys I wanted to add macros in the config section of dvswitch to shut down or restart my allstar node but when i close the app and restart the app it resets the macros I entered I believe I have t

Hello gentlemen of DVswitch. I have already experienced a few times that when I have too little 4G (Mobile data) signal, DV switch crashes. The PTT key turns red, and then transmits continuously. I ha

Hi All - I have some confusions and questions regarding DVSwitch and the App. I have DVSwitch up and running, but there's some things I can't seem to figure out and can't find a doc to explain it to m

I currently have a test system where I have bridged YSF and DMR using MMDVM_Bridge. I have the P25Reflector installed on the same system running as a standalone reflector. I would like to add P25 to t

Please excuse my stupidity, I am struggling to get my head around a problem I have. I have DVS running on a Rpi, in MMDVM_Bridge.ini I have the following settings -------------------------- Address=hb

I have separate MB ini files for each DMR network these are copied over the MB ini file and then MB service restarts. Which brings me to a question. When using these customised MB ini files, is it bes

Just an enquiry on a minor issue. I use DVSwitch Mobile on an Android device with no keyboard and a quite small screen. I am unable to enter Talkgroup numbers or commands as the on screen keyboard is

Hello Everybody! How i can do to change the default web port (80) of my DVSwitch Server with another port? Where i can find the program file to change this port?

Hello everyone. Is there much D-Star activity in the group? I've got a working xlxd reflector set up I use for a DStar group. Running on the same server, I have a working AllStar simplex radio node wi

Steve….   I did a apt-get install pip  and then not knowing about DMR utils did  a   pip install bitstring pip install bitarray pip install Twisted   I did get the following errors as noted i

What are the current best practices for setting up a link with Brandmeister to do a three-way transcode between DMR, YSF, and D-STAR? We’ve been running XLX330/311070/#83603 for awhile know using xlxd

Hi, Dvswitch ysf mode connects to the YCS server but does not transmit audio. Any tips? PU1LOY Luiz Sérgio

I have a link setup between a BM TG and an XLX server.. BMTG<>MMDVM<>MMDVM<>XLX Callsigns are appearing in the the XLX dashboard, but is there anyway to add a Prefix so that it shows the callsign is c

HI! How i can make a mediaplayer on my wordpress website? Like a media player directly connected to the rx monitor of my dvswitch dashboard?

Hello everyone, I am an Italian HAM iz8xoh and is since few time that I'm experimenting on this fronteer of interconnecting different nodes on different technologies. Have realized that for everybody

I finally got all my nodes green. I have 530782 setups on my DV Switch PI. Are there simple documents showing how to connect via the main node to the DV switch Node. I'm using analog ht being heard by

I posted an issue several months ago concerning getting the error message 'Network Watchdog Timeout' after any FCS transmission using an MMDVM_Bridge between FCS and DMR. Specifically this caused anot

The following message is showing in AB. Could someone tell me what this means, and how to fix it. "Your gatewayDmrId nnnnnnn is NOT in the subscriber f .net ile. Please correct this."